- Hem /
- Produkter /
- Dj-utrustning & effekter /
- Skivspelare /
- Element och reservnålar /
- Audio Technica /
- Audio Technica AT-33EV Dual Moving Coil Cartridge with Naked Elliptical Stylus
Audio Technica AT-33EV Dual Moving Coil Cartridge with Naked Elliptical Stylus
Inte tillgänglig? Här hittar du några alternativ.
Lagerstatus:
Uppskattad leveranstid vid lagd beställning: 3 veckor.
6 392 kr
-4%
6 112 kr
(inkl. 25% moms)
Audio Technica AT-33EV Dual Moving Coil Cartridge with Naked Elliptical Stylus
Produktnr: 9000-0099-0553
Garantitid:
Denna produkt levereras med 2 års garanti.
Allmänt
The Audio Technica AT-33EV dual moving coil cartridge has been furnished with an elliptical stylus to ensure precise tracking, a broad frequency response, bang-on channel separation and audio quality to match. This high-quality turntable cartridge comes complete with all of hardware needed to install it.
Tips eller kommentarer om den här produkten
- Please note: Since it's a moving coil cartridge (MC), the Audio Technica AT-SA is compatible with turntables that support MC cartridges only.
Specifikationer
Produktfunktioner
- Sustainable product not specified
- Färg guld/brons/mässing/koppar, röd
- Set nej
- Typ nål elliptisk
- Typ reservdel skivspelare cartridge
Vikt och mått inkluderar förpackning
- Vikt (inkl. förpackning) 400 gr
- Mått (inkl. förpackning) 10,5 x 10,5 x 5,0 cm
Produktspecifikationer
- frequency response: 15 Hz - 50 kHz
- channel separation: 30dB (1kHz)
- vertical tracking angle: 23°
- vertical tracking force: 1.6 - 2.2g (2.0g standard)
- needle construction: naked rectangular shank
- recommended load impedance: min. 100 Ohm (with head amplifier connected)
- coil impedance: 10 Ohm
- DC resistance: 10 Ohms
- coil inductance: 22µH (1kHz)
- output voltage: 0.3 (mV @ 1 kHz, 5 cm/sec)
- output channel balance: 0.5dB at 1kHz
- stylus: elliptical
- cantilever: duralumin
- static compliance: 40x10-6cm / dyne
- dynamic compliance: 10x10-6cm / dyne (100Hz)
- mount: half-inch centre
- dimensions: 16 x 16.6 x 26.5mm
- weight: 6.9g
- included:
- non-magnetic screwdriver
- 2x sealing rings
- 2x nuts
- installation screws (2x 13mm, 2x 19mm)
- plastic protective cap
- brush
- PCOCC lead wiring kit (AT6101)